LAMBER'TRON WIRING DIAGRAMS

Section
Drop element here!

LAMBER'TRON COLOR CODE

LAMBER'TRON 3-way w/1 Master Vol, 2 Vol, 1 Tone

Used in most MIJ and Electromatic Gretsch Models

Store image

Switch Positions:
Position 1 - Bridge
Position 2 - Bridge/Neck
Position 3 - Neck

This wiring schematic features a 3-way  toggle switch design. This diagram references the included Gavitt shielded "3-wire conductor" where the inner silver stranded wire is the independent ground, the inside black wire is the SOUTH coil (-) ground, and the inside white wire is the NORTH coil (+) hot signal wire.

NOTE:
*NOTE* If adding a middle pickup OR if using a single Lamber’Tron in combination with another manufacturers pickup and the in-between position(s) are OUT OF PHASE; simply swap the Lamber’Tron black wire and white wire, leaving the independent ground alone. If adding a middle pickup, i.e. a "HSH" type setup and the positions 2/4 are out of phase, make sure to swap the black and white wires on BOTH neck and bridge Lamber'Tron pickups.

LAMBER'TRON HSS 5-way w/1 Master Vol, 2 Tone

Store image

Switch Positions:
Position 1 - Bridge
Position 2 - Bridge/Middle (in phase)
Position 3 - Middle
Position 4 - Middle/Neck (in phase)
Position 5 - Neck

NOTE:
If using this diagram with other single coils and your position 2 is OUT OF PHASE; simple swap the black and white wires on the Lamber'Tron.